Inventory; Assembly; Attaching Router Table Wing - Grizzly T33850 Owner's Manual

Inventory

The following is a list of items shipped with your
item. Before beginning setup, lay these items out
and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 4)
A. Router Table Wing Assembly ..................... 1
B. Mounting Brackets ...................................... 7
C. Table Insert ⁄ " ........................................... 1
1
2
D. Table Insert 1" ............................................ 1
E. Table Insert 1 ⁄ " .......................................... 1
1
4
Table Insert 1 ⁄ " ......................................... 1
1
F.
2
G. Table Insert 2" ............................................ 1
H. Tap Screws M5.5 x 13 (not shown) ...........14
A
E F G
D C
Figure 4. T33850 inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the product and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model T33850 (Mfd. Since 08/23)
Assembling the Model T33850 consists of install-
ing the mounting brackets on the router table.
To assemble router table wing:
1.
Qty
B
The Model T33850 is designed to be mounted
between the front and rear rails on the right-hand
side of the table saw and bolted to either the table
saw extension wing or to the main table once the
extension wing has been removed.
If you choose to remove the table saw extension
wing and bolt the router wing to the main table,
you will have to drill two mounting holes in the rear
rail to complete the installation.
Before beginning the procedures below, be sure
to read the entire installation section.

Assembly

Install (7) mounting brackets in pockets on
underside of router table with (14) M5.5 x 13
tap screws, as shown in Figure 5.
x14
Mounting Brackets
(2 of 7)
Figure 5. Mounting brackets installed on
underside of router table.
Attaching Router
Table Wing
-9-