KTM 85 SX 2023 Owner's Manual page 79

–
Remove cotter pin
–
Remove screws
–
Press back the brake linings by slightly tilting the brake caliper
laterally on the brake disc. Carefully pull the brake caliper
backward from the brake disc.
–
Press the brake piston back into the basic position and ensure
that brake fluid does not flow out of the brake fluid reservoir,
extracting some if necessary.
–
6
Remove pin
–
Remove brake linings
–
Clean brake caliper.
–
Position the retainer spring.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
–
6
Mount pin
S04286-10
Info
To make it easier to mount the pin, push the brake lin-
ings against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
–
Mount cotter pins
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Correct the brake fluid up to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover
–
Mount and tighten screws
S04284-10
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
4
.
5
.
.
7
and the retainer spring.
.
4 .
5
.
M8 25 Nm (18.4 lbf ft)
A
.
5 mm (0.2 in)
p. 122)
2 3
with membrane .
1
.
BRAKE SYSTEM 12
Loctite ® 243™
77