Data Record Tmfastcontrolrec; Use And Structure Of Tmfastcontrolrec (Data Record 100) - Siemens SIMATIC S7-1500/ET 200MP Manual

Data record TMFASTControlREC

C.1

Use and structure of TMFASTControlREC (data record 100)

With the TMFASTControlREC data record, you manage the TM FAST application and read the
status information of the TM FAST application. The data are transferred to the module using
data record 100 (e.g. with the WRREC instruction) or read from the module (e.g. with the
RDREC instruction). You can conveniently perform these tasks using the instruction
LTMFAST_ControlREC (Page 31) (LTMFAST_typeControlREC_WR and
LTMFAST_typeControlREC_RD).
If errors occur during the transmission or validation of the data with the WRREC instruction,
you receive a corresponding error code in the STATUS output parameter. You can find a
description of the error codes in the section Validation error with data record 100 (Page 67).
Structure of data record 100 (TMFASTControlREC) for writing
The following table shows the structure of data record 100 for writing.
Table C- 1 Write data record 100
Bit →
Bit 7
Byte ↓
0
Version = 1
1
Command:
0 : Invalid
D
1 : Load TM FAST application from flash memory to FPGA
D
2 : Activate TM FAST application in FPGA
D
3 : Remove TM FAST application from FPGA
D
4 : Delete TM FAST application from flash memory
D
5 : Enable debug interface
D
6 : Disable debug interface
D
7 to 255 : Invalid
D
This command is only possible without errors when command status = 0 (following table Byte 1).
1
Technology module TM FAST (6ES7554-1AA00-0AB0)
Equipment Manual, 04/2023, A5E52301130-AA
Bit 6 Bit 5
1
1
Bit 4 Bit 3
1
1
Bit 2 Bit 1
C
Bit 0
63