Using Your Garage Door Opener - Chamberlain 98022 Manual

Operation

Using Your Garage Door Opener

FEATURES
Your garage door opener is equipped with
features to provide you with greater control
over your garage door operation.
Alert2Close
The Alert2Close feature provides a visual
and an audible alert that an unattended
door is closing.
TIMER-TO-CLOSE (TTC)
The TTC feature automatically closes the
door after a specified time period that can
be adjusted using a TTC enabled door
control (Models 881LMW or 880LMW).
Prior to and during the door closing the
garage door opener lights will blink and the
garage door opener will beep. myQ Remote
LED Light must be installed to use TTC or
myQ to control the door.
myQ
myQ allows you to control your garage
door opener from your mobile device or
computer from anywhere. myQ technology
uses a 900Mhz signal to provide two way
communication between the garage door
opener and myQ enabled accessories.
The garage door opener has an internal
gateway that allows the garage door opener
to communicate directly with a home Wi-Fi
network and access your myQ account.
MEMORY CAPACITY
SECURITY+ 2.0 ACCESSORIES
Remote Controls
Door Controls
Keyless Entries
myQ Accessories
THE PROTECTOR SYSTEM (SAFETY
REVERSING SENSORS)
When properly connected and aligned,
the safety reversing sensors will detect
an obstruction in the path of the infrared
beam. If an obstruction breaks the infrared
beam while the door is closing, the door
will stop and reverse to full open position.
If the door is fully open, and the safety
reversing sensors are not installed, or are
misaligned, the door will not close from
a remote control. However, you can close
the door if you hold the button on the door
control or keyless entry until the door is
fully closed. The safety reversing sensors
do not affect the opening cycle. For more
information see page 22.
LIGHTS
The garage door opener light will turn on
when the opener is initially plugged in;
power is restored after interruption, or
when the garage door opener is activated.
The light will turn off automatically after
4-1/2 minutes.
MEMORY CAPACITY
Up to 40
Up to 2 Smart Control Panels or 4 of any other
Security+ 2.0 door controls
Up to 4
Up to 16
25
USING YOUR GARAGE DOOR
OPENER
The garage door opener can be activated
through a wall-mounted door control,
remote control, wireless keyless entry or
myQ accessory. When the door is closed
and the garage door opener is activated the
door will open. If the door makes contact
with an obstruction or is interrupted while
opening the door will stop, opener beeps
and lights blink 5 times. When the door is
in any position other than closed and the
garage door opener is activated, the door
will close. If the garage door opener makes
contact with an obstruction while closing,
the door will reverse. However, you can
close the door if you hold the button on the
door control or wireless keypad until the
door is fully closed. The safety reversing
sensors do not affect the opening cycle.
The safety reversing sensor must be
connected and aligned correctly before the
garage door opener will move in the down
direction.
BATTERY BACKUP
The battery backup system allows access
in and out of your garage, even when the
power is out. When the garage door opener
is operating on battery power, the garage
door opener will run slower, the light will
not function, the Battery Status LED will
glow solid orange, and a beep will sound
approximately every 2 seconds.