Programming The Remote To Control A Vcr - RCA RV-9900 User Manual

Programming the Remote
Programming the Remote to Control
a VCR
To determine whether you need to program the
remote, turn on the VCR, point the remote at the VCR's
remote sensor, and press VCR1. Then, press the POWER
or CHAN UP or DOWN button to see if the VCR responds
to the remote commands. If not, you need to program
the remote.
Follow these steps to program your remote to control
your VCR:
1. Turn on the VCR.
2. Look up your VCR brand and code number(s)
in the code list on the next page or on the
code sheet packed with your remote.
3. Press and hold the VCR1 button on
the remote.
4. Enter the three-digit code from the code list.
5. Release the VCR1 button, then press POWER
to see if the VCR responds to the remote
commands. If not, try pressing VCR1
then POWER.
6. Repeat steps 3 through 5 using the next code
listed for your VCR brand until the VCR
responds to the remote commands.
28
This remote may not operate all
models of the brands shown.
To program the VCR2•LD button
to control a second VCR, follow
these steps but use the
VCR2•LD button instead of the
VCR1 button.