Assembling The Light Kit - Hunter Midtown 54211 Installation Manual

Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
Ceiling Bracket Downrod

Assembling the LIght Kit

2 of 3
Light Kit Screw
bag
1 of 3
Light Kit Screw
bag
hardware
Installing the Bulbs and Glass
Notch
Lift the globe and align the notches
in the globe with the tabs in the
light kit.
Hanging Fan Wiring
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
Carefully push all switch housing components into the switch
housing, then install the switch housing plate using two short light
kit assembly screws, found in the
Tab
Canopy Blades
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
hardware bag.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Bulbs/Glass Remote
1886
2 of 2
Short Light Kit
Screw
bag
8
Remote Cradle