Related Manuals for Hunter Loflin
Summary of Contents for Hunter Loflin
- Page 1 Loflin Installation Manual Model: 51801 Flat Matte Black 52599 Matte Fresh White Fan weight ±2 lbs: 26.7 lbs (12.1 kg) ©2023 Hunter Fan Co. PG4138 r032723...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Hunter Pro Tip: parts. The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component.
-
Page 4: Choosing The Right Installation Location
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 34° you will also need an Angled Mounting Kit. -
Page 5: Installing The Ceiling Bracket
You have two options for installation. Pick which one works best for your location. Remove any existing Hunter Pro Tip: bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. The machine screws are the ones that came with your outlet box. -
Page 6: Hanging The Fan
1886 Hanging the Fan NOTICE To prevent damage to fan, ALWAYS lift holding either the fan housing or the downrod. Place the downrod ball into the slot in the ceiling bracket. Progress Check: Your fan should look like this. Note: Fan style may vary. -
Page 7: Wiring The Fan
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a quali ed electrician. Hunter Pro Tip: You are going to need these:... - Page 8 1886 Installing the Canopy Insert the two canopy screws found in the hardware bag. Canopy Screw Lift the canopy into place so that the screw holes are aligned. Installing the Blades: Place each blade between a blade iron and medallion. Install three blade screws, found in the hardware bag, to attach the medallion to the blade iron.
-
Page 9: Assembling The Light Kit
1886 Assembling the Light Kit 2 of 3 1 of 3 Light Kit Screw Light Kit Screw Feed the wire plugs through the center Insert the third screw, Partially install two light kit hole of the upper switch housing, then found in the hardware assembly screws, found in the... -
Page 10: Preparing The Remote
1886 Preparing the Remote The remote control is To close the battery already paired for use. For compartment, secure your convenience, a remote the battery door to the transmitter assembly with function card is packed in the small Phillips head screw. with your remote. -
Page 11: Troubleshooting
Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. minor cosmetic blemishes; refurbished fans; and fans that are damaged due to any... - Page 12 1886 Downrod If you need a different downrod length follow these steps: Follow steps 1-5 to remove standard downrod pipe Here is another view of the downrod assembly unassembled. Follow steps 6-10 to reassemble with new downrod WARNING • Pin must be reinserted •...