Complete The Initial Setup; Set The Menu Language; Auto Channel Search; Tuning To A Channel - RCA 20F514TD User Manual

Connections & Setup

Complete the Initial Setup

Customizing items in the Setup menu allows your product to perform correctly. Make sure
you've connected the TV to cable or an off-air signal before you continue.
SETUP
Go back

Auto Channel Search

List & Labels
Closed Caption
Favorite Channel
Language Eng.
Format Normal
Auto Vol. Level Off
SETUP
Go back
Auto Channel Search
List & Labels
AUTO CHANNEL SEARCH
Closed Caption
Favorite Channel
Go back
Language Eng.
Source Type
Format Normal
Start Search
Auto Vol. Level Off
_12
analog channel
entry
012-1_ _
Digital channel
entry
1

Set the Menu Language

If English is your preferred language, skip this step and go to the Auto Channel
Search.
To choose another language, press the TV MENU button and then select OK.
This brings up the TV's Main menu. Press the down arrow button to highlight
Setup and press OK. From the Setup menu, highlight Language and press OK.
To choose a language other than English, press the right arrow button on the
remote.
Note: Make sure you're in TV mode by pressing the TV•DVD button.
auto Channel Search
Auto Channel Search is located from this path Main Menu/Setup/Auto Channel
Search. It allows your unit to search for all channels available through your
ANTENNA/CABLE INPUT jack. This is sometimes called auto programming.
1. From the Auto Channel Search menu press the right arrow button to choose
the Source Type (Cable or Antenna). The default is Cable.
Cable
2. With the Signal Source chosen, highlight Start Search and press OK. Auto
Channel Search runs as it finds all the available channels. The channel search
finds both analog and digital channels. (When searching for cable channels,
this step can take some time. It can take approximately 30 minutes).
3. Once the search is complete, your unit tunes to a channel. For information
on customizing your channels or menu options, go to Chapter 4.

Tuning to a Channel

The DIG•ANA button toggles between analog and digital channels. Analog
channels display in a rectangle as you enter the numbers. In the example to
the left, you can enter 12 or 012 to get the same channel. To enter a one-digit
channel, such as channel 8, just press 8. After entering the channel, press OK.
The CLEAR button on the remote clears all entries.
Digital channels can have both primary channels (like the analog channel
number) and subchannels. Digital channel numbers can contain up to six
numbers. Numbers to the left of the - (dash) are the main channel number;
numbers to the right are the subchannel numbers for stations that broadcast
more than one signal.
In the example, press "1", then press "2" (although 012 is shown in the example,
pressing "0" isn't required). Now press the right arrow button to move to the
subchannel. Press "1" and then "OK." Your product tunes to channel 12-1. If
channel 12 is broadcasting subchannel signals, you would enter numbers that
access the other signals. (Example: 12-1, 12-2, 12-3). If the selection times out,
you must start over.
Chapter 1