The definitions below describe the controls and functions
of the control panel (Figure 5).
1. Basler DGC-2020 Digital Genset Controller —
Displays parameters (AC voltage, AC current, phase,
frequency, fuel level, DEF level, oil pressure, engine
run hours, water/coolant temperature, and battery
voltage), as well as diagnostic trouble codes and
messages. Refer to the Basler Digital Genset
Controller section for more information.
2. Panel Light — Illuminates the control panel for
nighttime operation.
3. Voltage Regulator Control Knob — Allows ± 15%
manual adjustment of the generator's output voltage.
4. Main Circuit Breaker — This 3-phase, 1000-amp,
main circuit breaker protects the U, V, and W output
terminal lugs from overload. Located inside the control
box.
DCA70SSIU4FC8B 60 HZ GENERATOR • OPERATION MANUAL — REV. #0 (06/27/23) — PAGE 17
1
2
6
5
Figure 5. Control Panel
CONTROL PANEL
3
5. Panel Light Switch — When activated, will turn on the
control panel light. Make sure the panel light switch is
in the OFF position when the panel light is not needed.
6. Control Power Switch — Set this switch to the ON
position prior to operation. The digital controller will turn
ON. Make sure the switch is set to the OFF position
when operation has ended. This switch will be disabled
while the engine is running.
4