Engine Control Panel - MQ Power DCA40SSKU4F Operation Manual

The definitions below and on the preceeding page describe
the controls and functions of the Engine Control Panel
(Figure 5).
1. Engine Warning LEDs — There are six engine
warning lamps, they are defined as follows:
a. Engine Shutdown — Indicates that the engine
has shutdown due to an engine failure. LED will
turn on.
b. Engine Pre Alarm LED — Indicates that an engine
failure has occured. LED will turn on or blink.
c. Battery Charge Alarm LED — This LED is ON
when the output voltage of the alternator drops
below a set value. If this lamp is ON during normal
operation, the emergency shutdown system will
immediately stop the engine.
d. Fuel Filter Water Level LED — This LED is
ON when the water level in the fuel filter is
extraordinarily high.
PAGE 18 — DCA40SSKU4F 60 HZ GENERATOR • OPERATION MANUAL — REV. #0 (03/02/18)
6
1 2
R
ECU
Intergrated Gauge Control
A Low Oil Pressre
High temp.
B
Over Crank
Over Speed
C
Engine Started
D
E
3
F
G
4
H
5
Figure 5. Engine Control Panel

ENGINE CONTROL PANEL

V-W
U-V W-U
OFF
INCREASE DECREASE
e. Fuel Leak Detected Lamp LED — This LED is
ON when the fluid in the containment is higher than
the allowable level.
f. Pre-Heat LED — The pre-heat LED will be
ON during the pre-heating cycle (cold weather
conditions). When the pre-heat cycle is completed
the LED will turn OFF and the engine can be
started.
g. HEST LED — Hight Exhaust System Temperature
LED turns ON during the regeneration process.
When in this mode, the DPF exhaust temperature
is very high.
NOTICE
The area above and around the generator during
the regeneration process should be free of any type
of debris, flammable or conbustible materials, as
temperatures during the regeneration process can
reach as high as 1,022 °F (550 °C).
h. Manual Regeneration Request LED — This LED
turns ON to notify that the DPF regeneration is
required to reduce the increased soot levels.
Regeneration Start Pushbutton — Press this
i.
button to manually start the regeneration process.