Alarm And Relay Connector - Bosch Dinion2X Installation And Operation Manual

Dinion2X IP Camera
5.3

Alarm and relay connector

1
2
3
Figure 5.3 Alarm and relay connector pins
Pin
1
2
3
4
5
6
– Max. wire diameter AWG 22-28 for both stranded and
solid; cut back 5 mm (0.2 in) of insulation.
– Alarm output relay switching capability: Max voltage 30VAC
or +40 VDC. Max 0.5 A continuous, 10 VA.
– Alarm in: TTL logic, +5V nominal, +40 VDC max, DC coupled
with 22 kOhm pull-up to +3.3 V.
– Alarm in: configurable as active low or active high.
– Max. 42 V allowed between camera ground and each of the
relay pins.
Use the alarm input to connect external alarm devices such as
door contacts or sensors. A zero potential make-contact or
switch can be used as the actuator (use a bounce-free contact
system).
Use the alarm relay output for switching external devices such
as lamps or sirens.
Bosch Security Systems
This manual downloaded from http://www.manualowl.com
Alarm
4
5
6
Alarm socket
Alarm in 1
Alarm in 2
Relay out contact 1
Ground
Ground
Relay out contact 2
Installation and Operation Manual
5 mm
(0.2 in)
AR18-10-B006 | v1.1 | 2010.06
Installation | en 29