Dinion
| Installation Manual
XF
Alarm connector
Pin
1
2
3
4
•
Max. wire diameter AWG 22-28 for both stranded and solid
•
Default relay position n.o. (normally open), no alarm
•
Alarm output relay switching capability: Max voltage 30VAC or
+40VDC. Max 0.5 A continuous, 10VA.
•
Alarm in: TTL logic, +5V nominal, +40VDC max, DC coupled with
22kΩ pull-up to +3.3V
•
Alarm in: configurable as active low or active high
•
Max. 42V allowed between camera ground and each of the relay pins.
Lens mounting
The camera accepts both C and CS-mount lenses. DC-iris lenses are
recommended for the best picture performance. The camera automatically
detects the type of lens used and optimizes performance accordingly.
A spare male lens connector is provided.
Caution
To avoid damaging the CCD sensor when using a C-mount lens,
turn the red back focus ring counterclockwise until it stops (see
back focus adjustment) before mounting the lens.
Lenses weighing more than 0.5 kg (1. 1 lbs) must be separately
supported.
Bosch Security Systems | 2003-10 | V0.5
Alarm socket
Ground
Alarm in
Relay out contact 1
Relay out contact 2
EN | 10
Alarm
Pin 1
Pin 4