AT&T E2116 User Manual page 8

SELECT to move on to edit the number. Use
SELECT to move to edit the distinctive ring setting.
4. Press SELECT to save the edited information.
Delete a Number/Name Stored in Memory
1. Press and hold the memory location key (1 through 9) of the entry you wish to delete.
2. When the screen displays the entry you want to delete, press SELECT. Then press or until
ERASE flashes.
3. Press SELECT. The screen displays ERASE NO YES and the number.
4. Press or until YES flashes.
5. Press SELECT. You'll hear a confirmation beep.
Dial a Memory Number
1. Press and hold the memory location key (1 through 9) of the entry you wish to dial.
2. Press (phone) / FLASH to dial the displayed memory number.
Reassign Locations in Memory
1. Press and hold the memory location key (1 through 9) of the entry you
reassign.
2. When the screen displays the entry you want to reassign, press SELECT. Then press until
SPEED flashes.
3. Press SELECT. The screen displays ENTER 1-9.
4. Press the keys (1 through 9) to re-assign this entry into another memory
location. You will hear a confirmation beep.
Your E2116 (M/B) can store 20 (including nine speed dial entries) telephone numbers with names
(up to 15 characters for the name and 24 digits for the number in each location).
NOTE: Press (off) at any time to exit directory.
Store a Number/Name in the Directory
1. Press PROG. The screen displays DIRECTORY.
2. Press SELECT. The screen displays ENTER NAME.
3. Using the chart below, enter up to 15 characters for the name you're storing with the
number. Use to backspace and make corrections; use to advance and add a
space.
ENTER NUMBER.
5. Enter the telephone number. Use to backspace and make corrections. Press
REDIAL/PAUSE to store a pause in the dialing sequence.
-OR-
Press REDIAL/PAUSE to display the last number dialed from this phone.
6. Press SELECT or PROG. The screen displays DISTINCT RING? and the current
setting.
7. Press or to change the setting. Choose Y (for yes) if you wish the phone to alert you to calls
from this number by changing to a distinctive ringing pattern after the first ring. Choose N for a
normal ringing pattern.
8. Press SELECT or PROG to confirm your selection. If you chose Y, a will be displayed with
the directory entry.
NOTE: When memory is full the screen displays MEMORY FULL, an error tone sounds, and you
will not be able to store a new number until you delete a stored number.
Edit a Number/Name Stored in the Directory
to backspace and make corrections. Press
wish to