Speed Dial Memory; Telephone Memory; Enter Number - AT&T E2116 User Manual

Speed Dial Memory

You can store up to nine telephone numbers with names (up to 15 characters and 24 digits in
each location) into the speed dial memory locations you assign (1 through 9). You can also store
telephone numbers with names alphabetically in the directory. See Telephone Directory for
instructions.
NOTES:
• The entries you store in speed dial memory will be marked with 01 through 09 in the telephone
directory.
• Press (off) at any time to exit memory mode.
Store a Number/Name in Speed Dial Memory
1. Press PROG on the handset.
2. Press or until the screen displays SPEED DIAL.
3. Press SELECT. The screen displays ENTER 1-9.
NOTE: When memory is full the screen displays MEMORY FULL, an error tone sounds, and you
cannot store a new number until you delete a record in speed dial memory or telephone directory.
4. Press the key (1 through 9) for the memory location where you're storing this entry.
The screen displays ENTER NAME.
NOTE: If the location is not empty, your new entry will be stored in place of the old and the first
entry will be deleted. Take caution to not save over entries you do not wish to delete from
memory.
5. Using the chart below, enter up to 15 characters for the name you're storing with the
number. Use to backspace and make corrections; use to advance and add a
space.

Telephone Memory

6. When you finish entering the name, press SELECT or PROG. The screen displays

ENTER NUMBER.

7. Enter the telephone number. Use to backspace and make corrections.
REDIAL/PAUSE to store a pause in the dialing sequence.
-OR-
Press REDIAL/PAUSE to display the last number dialed from this phone.
8. Press SELECT or PROG to store your entry. The screen displays DISTINCT RING? andthe
current setting.
9. Press or to change the setting. Choose Y (for yes) if you wish the phone to alert you to calls
from this number by changing to a distinctive ringing pattern after the first ring. Choose N for a
normal ringing pattern.
10. Press SELECT or PROG to confirm your selection. If you chose Y, a will be displayed
the memory entry.
Edit a Number/Name Stored in Memory
1. Press and hold the memory location key (1 through 9) of the entry you wish to edit.
2. When the screen displays the entry you want to edit, press SELECT. Then press or until
EDIT flashes.
3. Press SELECT. The screen displays the name and number. The cursor
appears at the end of the name. Use , and the dial pad keys to edit the name. Press
Press
with