Telephone Operation - AT&T E2116 User Manual

3. Connect the telephone line cord to the wall jack.
4. Line up the tabs on the wall mount bracket with the slots on the bottom of the base unit. Snap
the bracket firmly in place.
5. Mount the base on the wall. Position the base unit so the mounting studs will fit into the holes
on the wall mount bracket. Slide the base unit down on the mounting studs until it locks into
place.

Telephone Operation

• While on a call, press to decrease the volume. A double beep will sound when you reach the
minimum setting.
• While phone is not in use, press to display caller ID information.
• While entering number or letters, press to delete last character entered.
PHONE () / FLASH
• To make a call, press then dial the number. or dial the number (use < to backspace and correct
digits), then press PHONE/FLASH ()
• During a call, press to receive an incoming call, if Call Waiting is activated.
• To answer a call, press this or any key except OFF.
• If you have call waiting service, you will hear a beep if someone calls while you are on a call.
Press REDIAL/PAUSE to put the first call on hold and take the new call. Press again to switch
back and forth between the calls.
HOLD
• Press to put a call on hold. Press again or press PHONE to release hold.
-OR-
• Use the extension to pick up the call.
CHAN/ DELETE
• Press to switch to a clear channel while on a call.
• When viewing the call log, press to delete the current record displayed.
• While handset is in idle mode,press and hold to delete all records in the call log.
SELECT
• Use SELECT in conjunction with PROG during handset programming.
• While on a call, press to transfer the call to the other handset.
• While on a call, press to increase the volume. A double beep will sound when you reach the
maximum setting.
• While phone is not in use, press to display phonebook entries.
• While entering letters, press to advance cursor.
OFF
• Press to end a call, or place handset in base or charger.
• While under program ming, press to exit.
• While under paging,press to cancel.
REDIAL/PAUSE
• To call last number dialed, press REDIAL/PAUSE, then press PHONE/FLASH . or
/ CID