Advertisement
6.
After installing the sensor cover, observe the cover if it is
upright and its centerline is aligned with that of the toilet
and squat. If any deviation occurs, remove the cover and
loosen the locking screws of the fixed bracket. Adjust the
fixed bracket for correctness. Fasten the screws and
reinstall the sensor cover after any adjustment.
Notice:
The central position and correctness of the
sensor will affect the proper operation of the
sensor.
INSTALLATION IN OTHER METHODS
a. Installation On Prefabricated Board
预制板安装法
Notice: For these two installation forms, the sensor must be installed according to rough-in.
注意：
以上两种安装形式，感应器的安装位置必须严格按尺寸图进行。
9
Prefabricated Board
预制板
+30
105
0
35
安装面板后，观察面板是否端正及其中心线是否与座/蹲便器
6.
在一条中心线上，如有偏差，取下面板，松开固定架的锁定螺
钉，调节固定架使其端正。调完后锁紧螺钉并重新装好面板。
注意：
感应器的中心位置及端正与否将影响感应器工作。
其它形式安装
+30
105
0
b. Installation On Decorating Panel
外加装饰板安装法
Decorating Panel
装饰板
35
1350669-T01-A
Advertisement
