HP ProCurve 2510 Management And Configuration Manual page 26

Getting Started
Need Only a Quick Start?
Im p o rt a n t!
1-6
For further information on ProCurve Networking switch technology,
■
visit the ProCurve website at:
www.procurve.com
Need Only a Quick Start?
IP Addressing
If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using multiple VLANs, ProCurve
recommends that you use the Switch Setup screen to quickly configure IP
addressing. To do so, do one of the following:
Enter setup at the CLI Manager level prompt.
■
ProCurve# setup
Or, run the Menu interface and select 8. Run Setup from the Main Menu.
■
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.
To Set Up and Install the Switch in Your Network
Use the Installation and Getting Started Guide shipped with your switch for
the following:
■ Notes, cautions, and warnings related to installing and using the
switch
Instructions for physically installing the switch in your network
■
Quickly assigning an IP address and subnet mask, setting a Manager
■
password, and (optionally) configuring other basic features.
■ Interpreting LED behavior.
For the latest version of the Installation and Getting Started Guide and other
documentation for your switch, visit the ProCurve Networking Web site.
(Refer to "Product Documentation" on page xv of this guide for further
details.)