HP ProCurve 2510 Management And Configuration Manual page 24

Getting Started
Sources for More Information
1-4
Screen Simulations
Figures containing simulated screen text and command output look similar
to this:
ProCurve(config)# show version
Image stamp: /sw/code/build/dosx(ndx)
Dec 11 2007 11:44:02
U.11.03
1340
Boot Image: Primary
Figure 1-1. Example of a Figure Showing a Simulated Screen
In some cases, brief command-output sequences appear outside of a
numbered figure. For example:
ProCurve(config)# ip default-gateway 18.28.152.1/24
ProCurve(config)# vlan 1 ip address 18.28.36.152/24
ProCurve(config)# vlan 1 ip igmp
Port Identity Examples
This guide describes software applicable to both chassis-based and stackable
ProCurve switches. Where port identities are needed in an example, this guide
uses the chassis-based port identity system, such as "A1", "B3 - B5", "C7", etc.
However, unless otherwise noted, such examples apply equally to the
stackable switches, which for port identities typically use only numbers, such
as "1", "3-5", "15", etc.
Sources for More Information
For additional information about switch operation and features not covered
in this guide, consult the following sources:
■ For information on which product manual to consult on a given
software feature, refer to "Product Documentation" on page xv.