HP ProCurve 2510 Management And Configuration Manual page 182

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
10-6
(for Edit). The cursor moves to the Enabled field for the first port.
2. Press
[E]
3. Refer to the online help provided with this screen for further information
on configuration options for these features.
4. When you have finished making changes to the above parameters, press
[Enter], then press
CLI: Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Commands
show interfaces brief
show interfaces config
show tech transceivers
interface
show spanning tree
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Using the CLI To View Port Status
Use the following commands to display port status and configuration:
show interfaces brief: Lists the full status and configuration for all ports
■
on the switch.
show interface config: Lists a subset of the data shown by the show
■
interfaces command (above); that is, only the enabled/disabled, mode, and
flow control status for all ports on the switch.
Syntax: show interfaces [ brief | config ]
These two commands display the information listed in
table 10-1, below.
Table 10-1. Comparing the "Show Interfaces" Command Options*
Feature Show Interfaces Brief
Port Number and Type
Enabled Y/N
Flow Control
Status Up/Down
Mode (Operating)
(for Save).
[S]
below
page 10-7
page 10-8
page 10-10
page 10-10
Show Interfaces Config
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No