Scheme View In Sequence; Spot View - Speco H16HRL User Manual

Live View Introduction

5.2.3 Scheme View In Sequence

Click StartSettingsSystemBasicOutput Settings to go to the interface as shown below.
Area ① displays all the sequence schemes; area ② shows the detailed information of the scheme; area ③ displays all the cameras and groups;
area ④ is the tool bar (
click "OK" to save the current display mode; other buttons are screen mode buttons).

Add Scheme
Click in area ① to create a new scheme. Click

Configure Scheme
a) Select a scheme in area ① and then click the screen mode button on the tool bar to set the screen mode of the scheme.
b) Select a camera window in area ② and then double click the camera or group in area ③. The camera or group will be added into the
selected window. One camera in the same scheme cannot repeat. You can click the right-click menu "Clear" in area ② to remove a single camera
or click to remove all the cameras.
c) Click "Apply" to save the settings.

Start Sequence View
Go to the live view interface and then click
view in sequence. Double click the sequence view interface to pause the view; double click again to restore the view. Click

5.2.4 Spot View

Click StartSettingsSystemBasicOutput SettingsOutput 2 to go to the interface as shown below.
: clear button; : favorite button, click it to pop up a window, enter the display mode name in the window and then
to open a window. Set the sequence interval in the window and then click
on the top right corner of the scheme to delete it.
23
DVR User Manual
to start scheme
to stop the view.