Power Connection - Siemens SIMOTICS T-1FW6 Operating Instructions Manual

Connection
6.2 Electrical connection
Figure 6-4
Table 6-4
PIN
1
2
3
4
5
6
6.2.4

Power connection

Table 6-5
Cable protection for motors connected in parallel electrically
For the following configurations, you require a circuit breaker for each motor as conductor
protection:
• Several motors are connected in parallel to one Motor Module.
• The current-carrying capacity of the feeder cable cross-section is less than the rated current
of the Motor Module.
72
Pin configuration, M17 signal connector
PIN assignment, M17 signal connector
Interface sensor pair 1
-1R2: 1. Pt1000
+1R1: 1. Pt1000
1TP1: 1. PTC 130°C
1TP2: 1. PTC 130°C
PE
Conductor assignment for power cables with open conductor ends
Color/identification
green/yellow
black / U / L1 / C / L+
black / V / L2
black / W / L3 / D / L-
Redundant interface sensor pair 2
-2R2: 2. Pt1000
2TP2: 2. PTC 130°C
2TP1: 2. PTC 130°C
+2R1: 2. Pt1000
PE
Connection
PE
U
V
W
1FW6 external rotor built-in torque motors
Operating Instructions, 03/2023, A5E49196960B AC