Extension Wings; Wood Extension Table - Delta 36-5052 T2 Manual

EXTENSION WINGS

For Models with Three Extension Wings
1.
Next attach the left side extension wing (3) to the front
and rear rails using four (5/16-18 x 1 1/8") flat head
screws, (5/16") lock washers, and (5/16-18) hex flange
nuts. See Figure (9a)
2.
Attach the left side extension wing (3) to the side of the
saw table using three (5/16-18 x 7/8") hex head screws
w/ spring washers. See Figure (9b)
3.
Lay the two remaining wings upside down on the saw
table. Place the two wings adjacent to each other,
so the holes patterns match. Fasten the two wings
together using three (5/16-18 x 7/8") hex head screws
w/ spring washers and (5/16-18) hex flange nuts.
4.
Turn the two wings fastened together over and fasten
them to side of the saw table using three (5/16-18 x
7/8") hex head screws w/ spring washers. See Figure
(8)
Note: Use a ruler to make sure the top edges of the wings are
flush with the top of the tabletop. See Figure (7)
Note: There are two set screws for the cast iron extension
wing. The set screws are used to adjust the level. See Figure
(8)
EXTENSION WINGS
For Models with Two Extension Wings and a Wood
Extension Table
1.
Attach the extension wings (3), to the Front and Rear
rails using four (5/16-18 x 1 1/8") flat head screws,
(5/16") lock washers, and (5/16-18) hex flange nuts.
See Figure (9)
2.
Attach the extension wings (3) to the table using three
(5/16-18 x 7/8") hex head screws w/ spring washers for
each wing. See Figure (9)
Note: Use a ruler to make sure the top edges of the wings are
flush with the top of the tabletop. See Figure (9)
Note: There are two set screws for the cast iron extension
wing. The set screws are used to adjust the level. See Figure
(8)
3.
Proceed to rail assembly.

WOOD EXTENSION TABLE

52" rip capacity models only
1.
Lay the wood table (A) upside down on floor or bench.
2.
Position legs (B) in corner as shown (Fig. 10) the
vertical wall of the angle plate on the leg should be
against the end wood wall (C) of the table.
3.
Fasten the legs to the table board with eight #8 x 3/4"
self-tapping screws (D).
ASSEMBLY
LEFT EXTENSION LEFT EXTENSION
WING WING
3
LEFT EXTENSION
WING
3
13
RIGHT EXTENSION RIGHT EXTENSION
RULER RULER
FIGURE 7
FIGURE 8
RIGHT EXTENSION
WING
3
RULER
FIGURE 9
FIGURE 10
WING WING
3