Polaris RANGER 570 2017 Owner's Manual For Maintenance And Safety page 83

Lights
Headlight Beam Adjustment
1. Position the vehicle on a level surface with the headlight approximately 7.6 m (25 ft.)
from a wall.
2. Place the transmission in PARK.
3. Measure the distance from the floor to the center of the headlight and make a mark on
the wall at the same height.
4. Apply the brakes. Start the engine. Turn on the
headlights.
5. Observe the headlight aim. The most intense part of
the headlight beam should be aimed 20 cm (8 in.)
below the mark placed on the wall. Include the weight
of a rider on the seat while performing this step.
6. If a headlight needs adjustment, locate the (3) three
adjustment screws at the rear of the headlight.
7. Loosen the screws, adjust the beam to desired
position, then tighten the screws.
8. Repeat steps 5-7 until the lamp is properly adjusted.
Brake Lights
When the brake pedal is depressed, the brake light comes on. Check the brake light before
each ride.
1. Turn the ignition switch to the ON position.
2. Depress the brake pedal. The brake light should come on after about 10 mm (0.4 in.) of
pedal travel. If the light doesn't come on, check the bulb.
Taillight/Brake Light/Turn Signal Lamp Replacement
The taillight assembly is not serviceable. If the taillight or brake light fails to operate prop-
erly, replace the entire taillight assembly.
Front Turn Signal Lamp Replacement
If a front turn signal light becomes inoperable, the lamps
cannot be replaced. Replace the entire signal lamp
assembly.
X
7.6 m
(25 ft.)
MAINTENANCE
20 cm (8" )
X
Adjustment Screw
81