Polaris RANGER 570 2017 Owner's Manual For Maintenance And Safety page 67

Engine Oil (570)
Oil and Filter Change
3. Clean the area around the drain plug.
CAUTION! Hot oil can cause burns to skin. Do not allow
hot oil to contact skin.
4. Place a drain pan beneath engine crankcase and
remove the drain plug.
5. Allow the oil to drain completely.
6. Reinstall the sealing washer on the drain plug.
Tip: The sealing surfaces on drain plug and crankcase
should be clean and free of burrs, nicks or scratches.
7. Reinstall the drain plug. Torque to 16 Nm (12 ft.
lbs.).
8. Using a cap-style oil filter wrench, turn the filter
counter-clockwise to remove it.
9. Using a clean dry cloth, clean the filter sealing
surface on the crankcase. Make sure the old
filter o-ring is completely removed.
10. Lubricate the o-ring on the new filter with a film
of fresh engine oil. Check to make sure the o-
ring is in good condition.
11. Install the new filter and turn by hand until the
filter gasket contacts the sealing surface, then
turn an additional 3/4 turn.
12. Always clean away all dirt and debris from the
dipstick area before removing the dipstick.
Remove the dipstick (or the oil fill cap on the
top of the engine) and fill the sump with 1.9
liters (2 qts.) of recommended oil.
13. Reinstall and tighten the dipstick.
14. Make sure the transmission is in PARK. Apply the brakes.
15. Start the engine. Allow it to idle for one to two minutes.
16. Stop the engine. Inspect for leaks.
17. Re-check the oil level on the dipstick and add oil as necessary to bring the level to the
upper mark on the dipstick.
18. Dispose of used filter and oil properly.
MAINTENANCE
Drain Plug Access
Oil Filter
65