Table of Contents
Advertisement
1
bag
Screw light kit screws from the
hardware bag halfway into
the motor housing. It does not
matter which two screw holes
you choose.
4
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Note:
Fan style may vary.
To install the shade, first loosen
the thumb screws. Raise the
shade to the light fixture. Tighten
all thumbscrews securely.
Repeat x4
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to
www.HunterFan.com/FAQs
and click "How do I install my
fan without the light kit?"
Ceiling Bracket
Downrod
Assembling the Light
2
2 of 6
Light Kit Screw
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
5
Partially install two of the light kit screws
found in the
hardware bag. Align the
notches in the sides of the lower switch
housing with the screws on the upper
switch housing. Twist the lower switch
housing clockwise to lock into place.
Installing the Bulbs and Glass
Note:
Fan style may vary.
Hanging Fan
Wiring
3
Insert a third screw, found in the
then tighten all three screws.
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
2 of 6
6
Light Kit Screw
bag
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Repeat x4
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy
Blades
Light Kit Screw
bag
hardware bag, into place and
WARNING
Light Kit Screw
bag
Install the last light kit screw.
Tighten all three screws securely.
WARNING
ON
Light
Glass/Bulbs
1886
1 of 6
1 of 6
8
Advertisement
Table of Contents
