Assembling The Light Kit - Hunter 50378 Installation Manual

Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Insert the third screw, found in the
bag, in place and firmly tighten all the three screws.
Note:
Fan style may vary.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Note:
Fan style may vary.
Ceiling Bracket Downrod

Assembling the LIght Kit

2 of 3
Light Kit Screw
bag
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 3
Light Kit Screw
bag
hardware
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the
Installing the Bulbs and Glass
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan Wiring
Align the keyhole slots in the top of the light kit
assembly with the partially installed assembly
screws. Wrap the keyhole slots around the
screws and twist counterclockwise.
bag
hardware bag.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Canopy Blades
2 of 2
Short Light Kit
Screw
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
ON
Light Glass/Bulbs
1886
8