Table of Contents
Advertisement
Partially install two light kit assembly
screws, found in the
hardware
bag, halfway into the motor housing
as shown. It does not matter which
two screw holes you choose.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the colored
markings on the connectors. Lift the lower switch
housing until its screw holes are aligned with the
screw holes in the upper switch housing.
Note:
Fan style may vary.
Install the included bulb into the
socket. When necessary, replace
with the bulb of same wattage.
Note:
Fan style may vary.
Ceiling Bracket
Hanging Fan
Assembling the LIght Kit
2 of 9
Light Kit Screw
bag
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Installing the Bulb and Cage
Cage
Assembly Screw
Lift the cage assembly into
place. Install three light kit
screws and tighten all three
screws securely.
Wiring
Canopy
Insert the third screw,
found in the
bag, into place and then
tighten all three screws.
Install the three switch housing
screws, found in the
hardware
bag. Tighten all three screws.
3 of 9
Light Kit Screw
bag
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades
Light
1 of 9
Light Kit Screw
bag
hardware
3 of 9
Light Kit Screw
bag
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Glass/Bulbs
Remote
1886
8
Advertisement
Table of Contents
