Table of Contents
Advertisement
3. Rotate the DIAL/ENT knob to speaker select "ALL",
"PA1" or "PA2", then press the [SELECT] soft key.
4. On the "Horn" and "Siren" modes, while pressing
the [HORN] soft key to activate the tone through the
HAIL/PA speaker.
Press the [FOG VOL] soft key, then rotate the DIAL/
ENT knob to control the AF output level. Press the
[ENTER] soft key. The AF output level can be set from
0 to 31.
5. To listen back, rotate the VOL knob.
6. Press the CLEAR key to return to radio operation.
8.14
INTERCOM OPERATION
The optional SSM-70H (RAM4) remote station microphone must be connected
to perform intercom functions between the GX6000E and the SSM-70H (RAM4).
When using the intercom function, connect one or two SSM-70H
(RAM4) Remote Station Microphone to the GX6000E.
8.14.1
Communication
[
] "IC"
1.
2. Rotate the DIAL/ENT knob to select the device to
which you want to communicate, then press the
[SELECT] soft key. The "" icon will appear at the
left side of the selected station.
Note: When only one SSM-70H (RAM4) is connected
to GX6000E, continue to step 5.
3. Repeat step 2 for all the desired devices.
4. Press the [ENTER] soft key.
5. When the intercom mode is enabled, "INTERCOM"
is displayed on the radio and SSM-70H (RAM4).
6. Press the microphone's PTT switch on the radio. "Talk"
will be shown on the display.
Note: A warning beep will be heard when the radio's
PTT and RAM4's PTT switches are pushed at the
same time.
GX6000E
NOTE
Page 47
Advertisement
Table of Contents
