Intercom Operation; Communication; Calling - Standard Horizon EXPLORER GX1700E Owner's Manual

8.10 INTERCOM OPERATION

An optional RAM3 ( CMP30 ) must be connected to perform intercom func-
tions between the radio and the RAM3 ( CMP30 ) .
In addition, To access the following Intercom functions one of the soft keys
must be setup as

8.10.1 Communication

1. Press the one of the Soft keys momentarily, then press the
key to enable the intercom mode.
Note: Depending on the programming of the
soft key, the
be pressed to see the
2. When the intercom mode
is enabled, " Intercom " is
displayed on the radio and
R A M 3 ( C M P 3 0 ) R e m o t e
Station Microphone.
3. Press the PTT switch on the
radio. " Talk " will be shown on
the display.
Note: A warning beep will
be heard if the PTT button
on the GX1700E and RAM3
( CMP30 ) microphone are pushed simultaneously.
4. Speak slowly and clearly into the microphone, hold the microphone about
1/2 inch away from your mouth.
5. When finished, release the PTT switch.
6. Press the
mode.

8.10.2 Calling

Press the
RAM3 ( CMP30 ) mic will produce a calling beep to the other station.
Page 34
. Refer to section "11.7 SOFT KEYS.
soft key may have to
soft key.
soft key to exit intercom mode and revert to radio
soft key when in intercom mode on either the radio or
GX1700E
( GX1700E's PTT switch is pressed )
GX1700E
( RAM3's PTT switch is pressed )
soft
RAM3
RAM3
GX1700E