Table of Contents
Advertisement
T 9800/T 982x
4.3
Residual Moisture Sensor Removal
1. Disconnect the appliance from the power supply.
2. Remove the dryer lid; refer to Section 010-4.1.
Note:
The residual moisture sensor is located at Figure D-1, Item 7.
3. Unhook the spring.
4. Press up on the plastic support to free it from the retainers on the cable
guide on the side panel.
5. Disconnect the two-pin Molex connector from the electronic, as well as
the ground wire from the rear panel of the appliance.
4.4
Drum Light Removal
1. Disconnect the machine from the power supply.
2. Remove the front panel. See Section 010-4.2.
3. Twist the light half a turn (180° counterclockwise) and remove it from its
housing on the air shield (see Figure D-1, Item 9, for location).
4. Free the two-pin wiring harness from the zip tie on the air shield (cut the
zip tie, if necessary) and the cable guide on the metal support plate.
4.5
Lightbulb Replacement
See the operating manual.
27
Technical Information
Advertisement
Table of Contents
