Residual Moisture Sensor Removal; Lightbulb Replacement; Figure 030-5: Residual Moisture Sensor - Miele T 80 Series Technical Information

T 80xx
4.5

Residual Moisture Sensor Removal

1. Disconnect the appliance from the power supply.
2. Remove the lid; see Section 010-4.1.
3. Remove the fascia panel; see Section 090-4.4.
4. Remove the control/power electronic; see Section 090-4.5.
5. Disconnect the residual moisture sensor wiring harness from the
control/power electronic and the green/yellow ground wire from the
appliance chassis.
6. Remove the T20 screw securing the residual moisture sensor to the
appliance chassis (Figure 030-5); release the sensor from the appliance.

Figure 030-5: Residual Moisture Sensor

4.6

Lightbulb Replacement

See the operating manual.
29
Technical Information