7 Unit installation
In this chapter
7.1 Preparing the installation site
7.1.1 Installation site requirements of the outdoor unit
EPRA14~18DAV3+W1 + ETVZ16S18+23EA6V+9W
Daikin Altherma 3 H HT F
4P644739-1 - 2021.02
7.1
Preparing the installation site ................................................................................................................................................
7.1.1
7.1.2
7.1.3
7.2
Opening and closing the units................................................................................................................................................
7.2.1
About opening the units ........................................................................................................................................
7.2.2
To open the outdoor unit ......................................................................................................................................
7.2.3
7.2.4
To close the outdoor unit.......................................................................................................................................
7.2.5
To open the indoor unit .........................................................................................................................................
7.2.6
7.2.7
To close the indoor unit .........................................................................................................................................
7.3
Mounting the outdoor unit ....................................................................................................................................................
7.3.1
7.3.2
7.3.3
7.3.4
To install the outdoor unit .....................................................................................................................................
7.3.5
To provide drainage ...............................................................................................................................................
7.3.6
To install the discharge grille .................................................................................................................................
7.3.7
7.4
Mounting the indoor unit.......................................................................................................................................................
7.4.1
About mounting the indoor unit............................................................................................................................
7.4.2
7.4.3
To install the indoor unit........................................................................................................................................
7.4.4
Choose an installation location with sufficient space for carrying the unit in and out
of the site.
NOTICE
This unit is designed for operation on 2 temperature zones:
▪
underfloor heating in the main zone, this is the zone with the lowest water
temperature,
▪
radiators in the additional zone, this is the zone with the highest water
temperature.
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
▪
Do NOT install the unit in places often used as work place. In case of construction
works (e.g. grinding works) where a lot of dust is created, the unit must be
covered.
INFORMATION
Also read the precautions and requirements in the
4
precautions" [
10].
7
Unit installation
|
49
49
52
52
53
53
54
54
54
55
57
58
58
58
58
58
59
60
62
63
65
65
65
65
66
"2 General safety
Installer reference guide
49