Installation; Removing Packaging Reinforcement; Opening The Transportation Locks - Beko WKD 23520 T Manual

2 Installation

Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.

Opening the transportation locks

A
Transportation safety bolts must be
removed before operating the washing
machine! Otherwise, the machine will
be damaged!
1. Loosen all the bolts with a spanner until
they rotate freely ("C")
2. Remove transportation safety bolts by
turning them gently.
3. Fit the covers (supplied in the bag with
the Operation Manual) into the holes on
the rear panel. ("P")
C
Keep the transportation safety bolts in
a safe place to reuse when the washing
machine needs to be moved again in
the future.
C
Never move the appliance without the
transportation safety bolts properly
fixed in place!
Adjusting the feet
A
Do not use any tools to loosen the lock
nuts. Otherwise, they can be damaged.
1. Manually (by hand) loosen the lock nuts
on the feet.
2. Adjust them until the machine stands
level and firmly.
3. Important: Tighten all lock nuts up
again.
Connecting to the water supply.
Important:
• The water supply pressure required to
run the machine must be 1-10 bar (0,1
– 1 MPa).
• Connect the special hoses supplied
with the machine to the water intake
valves on the machine.
• If you are going to use your double
water-inlet machine as a single (cold)
water-inlet unit, you must install the
stopper*, supplied with your machine to
the hot water valve.
• If you want to use both water inlets of
the product, you can connect the hot
water hose after removing the stopper
and gasket group from the hot water
valve.
* Applies for the products
supplied with a blind stopper group.
• Models with a single water inlet should
not be connected to the hot water tap.
When returning the appliance to its place after
maintenance or cleaning, care should be taken
not to fold, squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be attached to
the edge of a washbasin or bathtub. The drain
hose should be firmly fitted into the drain as to
not get out of its housing.
Important:
• The end of the drain hose must be
directly connected to the wastewater
drain or to the washbasin.
• The hose should be attached to a
height of at least 40 cm, and 100 cm at
most.
• In case the hose is elevated after
laying it on the floor level or close to
the ground (less than 40 cm above the
ground), water discharge becomes
more difficult and the laundry may
come out wet.
• The hose should be pushed into the
drainage for more than 15 cm. If it is
too long you may have it shortened.
• The maximum length of the combined
hoses must not be longer than 3.2 m.
29 - EN