Table of Contents
Advertisement
Figure2-30 Removing the power cord from a PSR450-12D power supply
(1) Use a flathead screwdriver to loosen the two screws on the power cord connector
(2) Pull the power cord connector out
Removing a PSR180-12A-F or PSR180-12A-B power supply
The removal procedure is the same for the PSR180-12A-F and PSR180-12A-B power supplies. The
following procedure removes a PSR180-12A-B power supply.
To remove a PSR180-12A-B power supply:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Disconnect the power cord.
3.
Loosen the captive screws on the power supply with a Phillips screwdriver until they are
completely disengaged.
4.
Grasp the handle of the power supply with one hand and pull it out a little, support the bottom
with the other hand, and pull the power supply slowly along the guide rails out of the slot.
Put away the removed power supply in an antistatic bag or the power supply package bag for
future use.
2
1
2-23
Advertisement
Table of Contents
