Table of Contents
Advertisement
2.
Align the round holes in the wide flange of one front mounting bracket with the screw holes in
the chassis. See Figure2-10.
3.
Use M4 screws (supplied with the switch) to attach the mounting bracket to the chassis.
4.
Repeat the preceding two steps to attach the other mounting bracket to the chassis.
5.
Unpack the shoulder screws and attach them to the chassis.
Two installation positions as red-marked in
Select one as required.
Figure2-10 Attaching the front mounting brackets and shoulder screws to the chassis
Attaching the rear mounting brackets to the rack
1.
Determine the switch installation position in the rack.
2.
Install cage nuts (user-supplied) in the rear rack posts. Make sure the corresponding cage nuts
on the left and right rear rack posts are at the same height.
3.
Orient the rear mounting brackets with the wide flange inside or outside the rack as required.
4.
Use M6 screws (user-supplied) to attach the rear mounting brackets to the rear posts, as shown
in Figure2-11.
Do not fully tighten the M6 screws before mounting the switch in the rack.
Figure2-10
are available for shoulder screws.
2-8
Advertisement
Table of Contents
