Table of Contents
Advertisement
Connect AV output of the NAVIGATION system to AV3 input of this unit and then select
NAVI IN ON on the CONTROL menu.
SETTING THE NAVIGATION SYSTEM
1. Press the MENU button until CONTROL menu is selected.
2. Press the SEARCH UP/DOWN button to select NAVI IN.
3. Press the VOLUME ◀ or ▶ button to select ON or OFF.
If a NAVIGATION system is connected to this unit, select ON and if it is not connected
to this unit, select OFF.
Each time you press this button, ON/OFF switches as follows.
OFF <--> ON
WATCHING THE NAVIGATION PICTURE
Press the NAVI button the remote controller on any AV mode. or press the MODE button
to select AV3 mode. The monitor shows the navigation picture
NOTE
When the shift (gear) is set at R(reverse) on NAVIGATION mode and a back view camera
is connected to this unit, the monitor shows the back view camera picture.
CONNECTION TO THE UNIT
Connect a NAVIGATION AV output only to AV3 Input on the rear of the unit with RCA jack
type AV wires only.
18
CONTROL MENU
CONTROL
NAVI IN
AV1
CAMERA IN
ON
SCREEN
NORMAL
NAVIGATION
Advertisement
Table of Contents
