Advertisement
TROUBLE SHOOTING
Before going through the check list, wiring connection, should any of the
problem persist after check list has been made, consult your nearest service
dealer.
Symptom
Cause
The car ignition is not on.
No power
The fuse is blown
Presence of CD disc inside
Disc cannot
the player
be loaded or
Inserting the disc in upside
ejected
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum
No sound
Wiring is not properly
connected
The operation
The built-in microcomputer
keys do not
is not operating properly
work
due to noise
The installation angle
Sound skips
is more than 30 degrees
The disc is extremely
dirty or defective
The radio does
not work
The antenna cable is not
the radio
connected
station
the signals are too weak
automatic
selection does
not work
Solution
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
Replace the fuse
Remove the disc in the player
then put a new upward
Insert the compact disc with
the label facing upward
Clean the disc or try to play a
new one
Cool off until the ambient
temperature returns to normal
Leave the player off for an
hour or so, then try again
Adjust volume to a desired level
Check wiring connection
Press the RESET button
front panel is not properly
fix into its place
Adjust the installation angle
to less than 30 degrees
Clean the compact disc/try to
play a new one
Insert the antenna cable firmly
select a station manually
7
BALANCE CONTROL
1). Press the SEL button to select the balance mode until BAL appears on the display.
2). Press the + button or - button to increase or decrease the sound level of
left or right speaker.
FADER CONTROL
1). Press the SEL button to select the fader mode until FAD appears on the display.
2). Press the + button or - button to increase or decrease the sound level of
front or rear speaker.
2. OPEN BUTTON
Press it to eject the front panel when you want to take away.
3. BAND BUTTON
Press it to select your desired radio band and word which band is selected
will be displayed on LCD.
4. LCD ( LIQUID CRYSTAL DISPLAY)
5. CD
( CD PLAY, PAUSE) BUTTON
At tuner mode, press
button to switch to CD mode. At CD mode,
press it to pause the CD program and press it again to resume CD
playback.
6. EJECT BUTTON
Press it to eject the disc from the slot.
7. DSP( DISPLAY) BUTTON
Press it to apply those functions, press it continually to switch between 4
preset equalizer curves: FLAT, POP, CLAS, ROCK. The sound quality will
be changed. Press it again to resume initial default mode.
8. MUTE BUTTON
Press this button to eliminate the sound temporarily, press it again to
resume normal play state.
4
Advertisement
