Troubleshooting - Pyle PLCD43BTM User Manual

TROUBLESHOOTING

The following chart will help in solving most problems that may occur.
If you still have questions after going through the checklist, please consult your local customer service
representative. Before going through this check list, refer the wiring and operating procedures.
Symptom
No power
Disc can not be loaded
or ejected.
No sound
Sound skips
The operation keys
do not work
No radio reception.
In automatic search mode
the radio does not stop at
a transmitting station.
Cause
The car ignition switch
have not turn on.
The fuse has been blown.
Presence of CD disc inside
the player.
Inserting the disc in reverse
direction.
The surface of CD is
extremely
dirty or has been scraped.
Temperature inside the car
is too high.
Condensation
Volume is in minimum.
The wiring is not properly
connected.
The installation angle is
more than 30°.
The surface of CD is
extremely dirty or has been
scraped.
1. The built-in micro-
computer is not operating
properly due to noise.
2. The front panel has not
properly installed.
The antenna cable is not
connected.
The transmission signals
are too weak.
- 14 -
Solution
If the power supply is connected to
the car accessory circuits, but the
engine is not moving, switch the
ignition key to "ACC".
Replace a new one.
Remove the disc from the player,
and insert a new one.
Insert the CD with the label facing
upward.
Clean the disc or try to replace
a new one.
Cool off or until the ambient
temperature return to normal.
Leave the player off for an hour or
so, and then try again.
Adjust volume to a desired level.
Check wiring connection.
Adjust the installation angle less than
30°.
Clean the disc or try to replace
a new one.
1. Press the RESET button to
restore the program.
2. Fixed the front panel into its place.
Insert the antenna cable firmly into
the antenna socket of this radio
player.
Select a radio station manually.