KTM 250 SX-F 2023 Owner's Manual page 88

12 BRAKE SYSTEM
86
Info
Do not operate the hand brake lever if the brake caliper
has been removed.
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and the brake caliper bracket.
F03696-10
–
Check that spring plate
sliding plate
rectly.
F03692-10
–
Insert the new brake linings, insert pin
5
pins .
Info
Always change the brake linings in pairs.
To make it easier to mount the pin, push the brake lin-
ings against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
F03696-10
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
S05364-10
5 6
, pull out pin , and remove the
7
in the brake caliper and brake pad
8
in the brake caliper bracket are seated cor-
6
4
.
M8 25 Nm (18.4 lbf ft)
, and mount cotter
Loctite ® 243™