Transmitting Using Radio Programmed For Non-Talkback Scan; Making A Dynamic Priority Change (Conventional Scan Only); Deleting A Nuisance Channel - Motorola APX MOBILE O9 User Manual

68007024014-GK
Advanced Features
2.5.2.2

Transmitting Using Radio Programmed for Non-Talkback Scan

Procedure:
Press the PTT button at any time to transmit on the selected channel or fixed channel.
To make a Call Alert page, or Private Conversation call while scanning, press either the Menu
Select button directly below page or call. The call is entered on the selected channel and
scanning is halted until the call is exited by pressing
below either page or call.
2.5.3

Making a Dynamic Priority Change (Conventional Scan Only)

When and where to use:
While the radio is scanning, the dynamic priority change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One channel) to the Priority-Two channel.
This change remains in effect until scan is turned off. Scan then reverts to the default setting.
Do one of the following to make a Dynamic Priority Change. You can use the options interchangeably
depending on your preference and the programmed functions.
Procedure:
• Making a Dynamic Priority Change using the preprogrammed Dynamic Priority button:
a. When the radio locks onto the channel designated as the new Priority-Two channel, press
the preprogrammed Dynamic Priority button.
The radio continues scanning the remaining channels in the list.
• Making a Dynamic Priority Change using the radio menu:
a. Press the Menu Select button directly below DynP to change the priority of a non-priority
channel in the scan list to Priority-Two.
b. Press momentarily to exit the scan list and resume scanning.
2.5.4

Deleting a Nuisance Channel

When and where to use:
If a channel continually generates unwanted calls or noise (termed "nuisance" channel), you can
temporarily remove the unwanted channel from the scan list.
This capability does not apply to priority channels or the designated transmit channel.
NOTICE: Deleting a nuisance channel is only possible through the preprogrammed Nuisance
Channel Delete button. This feature is not accessible through the menu.
Procedure:
When the radio is locked onto the channel to be deleted, perform one of the following actions:
• Press the preprogrammed Nuisance Delete button.
• or to NuisDel and press the Menu Select button directly below NuisDel.
The radio continues scanning the remaining channels in the list.
66
or pressing the Menu Select button