Stanley ST-12F-E User's Manual And Operating Instructions page 21

1. Align the screw hole on the side of the fan head with both the rubber ring
and the hole on the support bracket; spring loaded button of the support
bracket is facing the fan, see Fig. 9.
2. Insert the screw knob and tighten up.
3. Repeat above process for opposite side of fan.
4. Align Cradle Base (packed separately) with support brackets attached to
fan body sides. Note: you may need to flex the parts to make them align
properly, see Fig 2
5. Insert support bracket into opening of Cradle Base. Press spring loaded
button down to allow it to insert into Cradle Base, see Fig 3.
6. Press support bracket into Cradle Base until spring button protrudes out
open hole in Cradle Base, see Fig. 4.
7. Repeat above process for opposite side of fan.
1. Take out the all spare parts from
box, fix the metal tube on the fan
body. See Figure 5.
2. Install wheels(Fx2) on the two sides
of short metal tube(Cx1), then fix
it to the bend metal fan(Bx2). See
Figure 6.
3. Install the long metal tube(Dx1) to
the other side of bend metal tube.
See Figure 7.
4. Insert the metal tubes into the metal
base by pressing spring buttons.
See figure 10. See Figure 8.
© 2023, Obelis S.A Registered Address:
Bd. Général Wahis, 53 1030 Brussels, Belgium
Figure 10
Spring
Button
Metal
Tube
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A
ST-20FOMNI-E
ST-24DCT-E
Ax1 Bx2
Fx2 Hx2
Figure 5
Ax1
Ix2
Hx2
Ex4
Figure 7
5
POWER SOURCE
Fig. 9
Cx1 Dx1
Ix2 Jx2
Figure 6
Cx1
Figure 8
Jx2
Dx1
Rubber
Ring
Screw
Knob
Support
Bracket
Ex4
x1
Fx2
Bx2