Download Print this page

Stanley FT10 Installation & Commissioning Instructions

Fan flue for brandon dry/dhw & donard oil & gas cookers

Advertisement

Quick Links

Waterford Stanley Ltd.
Bilberry, Waterford Ireland.
Tel: (051) 302300 Fax: (051) 302375
FT10 FAN FLUE FOR
BRANDON DRY/DHW & DONARD OIL & GAS COOKERS
INSTALLATION & COMMISSIONING INSTRUCTIONS

Advertisement

loading

Summary of Contents for Stanley FT10

  • Page 1 Waterford Stanley Ltd. Bilberry, Waterford Ireland. Tel: (051) 302300 Fax: (051) 302375 FT10 FAN FLUE FOR BRANDON DRY/DHW & DONARD OIL & GAS COOKERS INSTALLATION & COMMISSIONING INSTRUCTIONS...
  • Page 2: Table Of Contents

    Position in FT10 Powered Flue for Gas Fired Cookers ....... .
  • Page 3: Exploded View

    POSITION OF FT 10 POWER FLUE FOR GAS FIRED COOKERS Car port (open sides) GAS FIRED COOKERS - MINIMUM DISTANCES TO TERMINALS ARE AS FOLLOWS: Directly below an opening, air brick, window etc. Below a gutter, eaves or balcony with protection. Below a gutter or a balcony without protection.
  • Page 4: Position In Ft10 Powered Flue For Gas Fired Cookers

    POSITION OF FT 10 POWER FLUE FOR OIL FIRED COOKERS OIL FIRED COOKERS Directly below an opening, air brick, window etc.. Horizontally to an opening, air brick, window etc.. Below a gutter, eaves or balcony with protection Below a gutter or a balcony without protection From vertical sanitary pipework From an internal or external corner Above ground or balcony level...
  • Page 5: Ft10 Dry Power Flue Kit Assembly & Installation With Brandon Dry & Dhw Cookers

    FT 10 DRY POWER FLUE KIT ASSEMBLY AND INSTALLATION WITH BRANDON DRY & DHW COOKERS SEE EXPLODED VIEW (FIG 8) WHEN ITEM NUMBERS ARE REFERRED TO: INSTALLATION Fig.4 Fig.6 STEP 1. (a) Remove the air inlet plate on the bottom right hand corner on the front of the cooker.
  • Page 6: Ft10 Fan Flue Kit Assembly & Installation With Donard Gas Cookers

    FT10 FAN FLUE KIT ASSEMBLY AND INSTALLATION WITH DONARD OIL & GAS COOKER SEE EXPLODED VIEW (FIG 1.) WHEN ITEM NUMBERS ARE REFERRED TO: STEP 1. (c) Push on Air inlet duct (item 5.) (b) With the cover hinged down as...
  • Page 7: Electrical Connection

    COMMISSIONING (a) Make the necessary adjust- ments to the burner air STEP 1. Note: The FT10 Fan Flue comes adjuster and the fan speed Isolate the mains supply to the set up for use with Brandon Dry & controller.
  • Page 8: Brandon Dry Gas Ft10 Power Flue Wiring Diagram

    BRANDON DRY GAS FT 10 POWER FLUE WIRING DIAGRAM...
  • Page 9: Donard 60K Gas Ft10 Power Flue Wiring Diagram

    DONARD 60K GAS FT 10 POWER FLUE WIRING DIAGRAM...
  • Page 10 BRANDON DRY & DHW OIL FT 10 POWER FLUE WIRING DIAGRAM...
  • Page 11 DONARD 60K OIL FT 10 POWER FLUE WIRING DIAGRAM Waterford Stanley Bilberry, Waterford, Ireland. Telephone: (051) 302300 Facsimile: (051) 302375 Rev:001 DP000217...