Table of Contents
Advertisement
3 3 . . 7 7
U U P P S S C C o o n n n n e e c c t t i i o o n n w w i i t t h h o o u u t t H H o o t t s s w w a a p p M M B B P P M M o o d d u u l l e e
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power
source and the true electrical consumption of the total load.
1
Note. The UPS charges the battery as soon as it is connected to the AC-power source, even if the
is not pressed.
Once the UPS is connected to the AC-power source, eight hours of charging are required before the
battery can supply the rated backup time.
7
5
6
19
16
15
UPS Connection without Hotswap MBP Module
1. Connect the UPS input socket
to the AC-power source using the
cable of the protected equipment.
2. Connect the loads to the UPS.
It is preferable to connect the
priority loads to the outlets
marked
and the non-priority
5
loads to the outlets marked
that can be programmed.
For the 9PX 3000RTAU model,
connect any high-power devices
to the 16 A outlet.
To program shutdown of outlets
during operation on battery
6
7
power and thus optimise
the available backup time,
please check the in/out settings.
3. Fit the connection securing system
that prevents the plugs from
19
being pulled out accidentally.
Eaton 9PX Lithium-Ion
P-164001006—Rev 01
1
6
7
21
Advertisement
Table of Contents
