Connection With A Hotswap Mbp Module ( Optional Accessory) - Eaton 9PX1000IRTANZ-L User Manual

Connection with a Hotswap MBP Module ( Optional Accessory)

3 3 . . 8 8 C C o o n n n n e e c c t t i i o o n n w w i i t t h h a a H H o o t t s s w w a a p p M M B B P P M M o o d d u u l l e e ( ( O O p p t t i i o o n n a a l l A A c c c c e e s s s s o o r r y y ) )
The HotSwap MBP module makes it possible to service or even replace the UPS without affecting the connected
loads ( HotSwap function).
1
HotSwap MBP
29
HotSwap MBP module operation
31 32
UPS start-up with the HotSwap MBP module
1. Check that the UPS is correctly connected to the HotSwap MBP module.
2. Set switch to Normal position.
33
3. Start the UPS by pressing the ON/OFF button
The load is supplied by the UPS.
LED
"UPS ON - OK to switch" on the HotSwap MBP module goes ON.
31
22 Eaton 9PX Lithium-Ion
HotSwap MBP module test
1. Set switch to Bypass position and check that the load is still supplied.
33
2. Set switch back to Normal position.
33
28
30 31 32 33 34
LOAD
33
P-164001006—Rev 01
5
9PX 3000RTAU:
1. Connect the input socket
the HotSwap MBP module to the
AC-power source using the cable
15
2. Connect the UPS input socket
1
6 7
HotSwap MBP module, using the
cable
and the connectors are marked
blue.
3. Connect the UPS outlet
"UPS Output"
MBP module, using the cable
supplied.
These cables and the connectors
are marked in red.
4. Connect the equipment to the
35 36
outlets
MBP module. These outlets differ,
depending on the version of the
HotSwap MBP module.
15
Caution. Do not use UPS outlets
to supply equipment because use
of switch
module would cut supply to the
equipment.
The HotSwap MBP module has a rotary
switch
33
Normal the load is supplied by the UPS,
LED
Bypass the load is supplied directly by
the AC-power source. LED
is on.
on the UPS control panel.
on
36
supplied.
to the "UPS Input" on the
35
supplied. These cables
28
to the
5
on the HotSwap
34
28
and on the HotSwap
29 30
on the HotSwap MBP
33
with two positions:
is on.
31
32