Table of Contents
Advertisement
Physical Descriptions
NetVanta 1531P Front Panel Design
The NetVanta 1531P front panel is shown below.
Appendix A on page 47
shows the connector pinouts.
Front Panel Features
Status LED
The STAT LED is located on the left side of the unit and indicates the unit's status.
Link/Activity LED
The LINK/ACT LED is located on the left side of the unit and indicates that the port LEDs 1 through
8 are displaying link/activity status.
Power over Ethernet LED
The PoE LED is located on the left side of the unit and indicates that the port LEDs 1 through 8 are
displaying PoE status.
LED Mode Switch
The LED mode switch is located on the left side of the unit and is used to toggle Ports 1 through 8
between link/activity and PoE display modes.
CONSOLE Interface
The CONSOLE interface is an EIA-232 serial port (DCE) that provides local management and
configuration (via a DB-9 female connector). Refer to
Connection directly to an external modem requires a cross-over cable.
10/100/1000Base-T Ethernet Interfaces
The front panel contains 10 10/100/1000Base-T Ethernet interfaces (RJ-45). These interfaces are
arranged in stacked pairs, with the numbers 1 through 10 screened from left to right directly above the
corresponding ports. Status LEDs for each stacked pair of interfaces are located directly over the
interfaces. Refer to
Table A-2 on page 47
SFP Slots
The front panel contains two industry standard SFP slots for fiber connectivity. The interfaces
numbered 11 and 12 support 1000Base-X SFP modules and their status LEDs are located directly
above the interfaces. Refer to
12
Table 1 on page 25
1
2
3
4
STAT
LINK/ACT
PoE
CONSOLE
Figure 3. NetVanta 1531P Front Panel Layout
for pinouts.
Table A-3 on page 48
Copyright © 2019 ADTRAN, Inc.
NetVanta 1531/1534/1544 Series
describes all of the LEDs, and
5
6
7
8
9
10
11
12
NetVanta1531P
Table A-1 on page 47
for pinouts.
for pinouts.
61702590G1-34H
Advertisement
Table of Contents
