Toyota Sequoia 2018 Manual page 409

Table of Contents

Advertisement

Drive straight (with occasional left and right turns) at approxi-
2
mately 25 mph (40 km/h) or more for approximately 10 to 30 min-
utes.
Registration is complete when the tire pressure warning light
turns off and the inflation pressure of each tire is displayed on the
multi-information display.
Registration may take longer than approximately 30 minutes in
certain situations, such as when the vehicle is stopped for a long
time at traffic lights, etc. (
After registering the ID codes, make sure to initialize the tire
pressure warning system. (
When to replace your vehicle's tires
Tires should be replaced if:
The treadwear indicators are showing on a tire.
You have tire damage such as cuts, splits, cracks deep enough to
expose the fabric, and bulges indicating internal damage
A tire goes flat repeatedly or cannot be properly repaired due to the size
or location of a cut or other damage
If you are not sure, consult with your Toyota dealer.
When replacing the tires and wheels
If the ID code of the tire pressure warning valve and transmitter is not reg-
istered, the tire pressure warning system will not work properly. After driv-
ing for about 20 minutes, the tire pressure warning light blinks for 1
minute and stays on to indicate a system malfunction.
Tire life
Any tire over 6 years old must be checked by a qualified technician even
if it has seldom or never been used, or damage is not obvious.
Routine tire inflation pressure checks
The tire pressure warning system does not replace routine tire inflation
pressure checks. Make sure to check tire inflation pressure as part of
your routine of daily vehicle checks.
SEQUOIA_OM_USA_OM0C011U
6-3. Do-it-yourself maintenance
P. 412)
P. 407)
409
6

Advertisement

Table of Contents
loading

Table of Contents