Adjusting The Recording Sound - Sony DVCAM DSR-200P Operating Instructions Manual

Adjusting the recording sound

You can adjust the recording sound level. Use headphones (not supplied) to monitor
the sound when you adjust.
Selecting and setting audio mode
You can record sound using channel 1 and channel 2.
Select sound input using the LINE/MIC switch as follows:
MIC FRONT: When recording from the built-in microphone or external microphone
connected to MIC (PLUG IN POWER) jack.
MIC REAR: When recording from on external microphone connected to AUDIO IN
CH-1 or/and CH-2.
LINE: When recording from line-in connected to AUDIO IN CH-1 or/and CH-2.
LINE/MIC switches position and recording sound
LINE/MIC switch
position
CH-1 CH-2
MIC FRONT MIC FRONT
LINE
MIC REAR
MIC REAR MIC REAR
LINE
MIC FRONT
LINE LINE
MIC FRONT
MIC REAR
* External microphone connected to MIC (PLUG IN POWER) jack. This "–" means no connection.
Notes on recording
• Be sure to set LINE/MIC positions properly, otherwise no sound will be recorded.
• When nothing is connected to the XLR connector and you set the LINE/MIC switch
to MIC REAR, a noise may occur.
• When both CH-1 and CH-2 LINE/MIC switches are set to FRONT, both audio level
of CH-1 and CH-2 are adjusted by CH-1 REC LEVEL dial.
AUDIO IN CH-1
AUDIO IN CH-2
Microphone Recording
type*
CH-1
— Built-in mic: L
Stereo External mic: L
Monaural External mic: Mono
— Built-in mic: L+R
Stereo External mic: L+R
Monaural External mic: Mono
— Built-in mic: L+R
Stereo External mic: L+R
Monaural External mic: Mono
— XLR MIC
— XLR MIC
—
Stereo XLR MIC
Monaural
— XLR LINE
—
Stereo XLR LINE
Monaural
— XLR LINE
MIC (PLUG IN POWER)
Built-in microphone
CH-1 LINE/MIC
CH-2 LINE/MIC
DSR-200P CE 3-858-622-12(1). E
sound
CH-2
Built-in mic: R
External mic: R
External mic: Mono
XLR LINE
XLR MIC
XLR MIC
XLR LINE
Built-in mic: L+R
External mic: L+R
External mic: Mono
XLR LINE
Built-in mic: L+R
External mic: L+R
External mic: Mono
XLR MIC
65