Advertisement
7. HG532t
a. Splitter MODEM port
3 Powering On the HG532t
After you connect the cables, power on the HG532t by pressing the On/Off button on its side
panel.
After you power on the HG532t, the Power indicator lights up,the ADSL indicator lights up
and starts blinking, indicating that the ADSL port is being activated. The blinking may last
from 40 seconds to 3 minutes. When the ADSL indicator stops blinking and turns steady on, it
indicates that the cables are connected correctly and the HG532t has been activated using
ADSL.
4 Setting Network Access Parameters
Configuring a Dial-Up Connection for Internet Access
By default, the HG532t works in routing mode. The HG532t starts to set up a dial-up
connection automatically after you power it on. You do not need to install any dial-up
software or perform any dial-up operations on your computer.
To set up a dial-up connection for Internet access:
Step 1 Launch a browser on your computer. Enter http://192.168.1.1 in the address box,
and press Enter.
Step 2
Step 3 On the login page, enter your user name and password.
By default, the user name is user and password is user.
For security reasons or to make the password easy to remember, you can
change the user name and password for login. For details, check the HG532t
user guide.
Step 4 Click Login.
Step 5 Choose Basic > WAN to display the WAN tab.
Step 6 Click Next.
Step 7 In User name and Password, enter the user name and password that are provided by
your service provider, and then click Next.
Step 8 Choose Basic > WLAN to display the WLAN tab.
Step 9 In SSID and WPA pre-shared key, set the wireless network name and password.
Use the default settings for other parameters.and then click Submit.
b. Splitter PHONE port
3
c. Splitter LINE port
Advertisement
