Table of Contents
Advertisement
2 Getting Started
After you connect the cables, please press down the ON/OFF button on the side of the
HG530 to power on the HG530.
After you power on the HG530, the Power indicators turns on and the ADSL indicator
blinks (for less than three minutes), which indicates that the HG530 is being activated.
After the ADSL indicator blinking, the Power and ADSL indicators keep solid on,
which indicates that the HG530 is working properly.
3 Setting the Network-Access Parameters
3.1 Accessing
Embedded PPP Dial-Up Software on the HG530
If you select this method for accessing the network, the HG530 starts to set up a dial-up
connection automatically after the startup. You can access the network after you power
on your computer. You do not need to install any special dial-up software on your
computer or perform dial-up operations on your computer. To configure the HG530 and
your computer for the network access, do as follows:
Step 1
Verify the HG530 and the PC have connected properly, and the PC has
obtained the IP address.
Step 2
Log in to the Web-based configuration utility of the HG530.
1. Launch the Internet Explorer on your computer. Enter http://192.168.1.1
in the address bar, and then press Enter.
2. In the displayed dialog box, enter the user name and the password, and
then click OK.
By default, both the user name and the password are admin. After the user name and
the password are verified, you can access the Web-based configuration utility.
Step 3
Enable the embedded dial-up function.
1. In the navigation tree on the left of the Web-based configuration utility,
choose Basic > WAN Setting.
2. Select a PVC number, such as 1, from the PVC drop-down combo box.
3. Enter the VPI and VCI that are provided by the network operator in the
VPI and VCI text boxes.
the
Network
8
Through
the
Advertisement
Table of Contents
