Table of Contents
Advertisement
INSTALLING AND USING THE ECELL
Using the Setup Wizard
Note:
When using a 3G/4G network, verify a SIM card has been installed before powering on and starting setup.
Configure the device using the web UI. To access the web UI, enter the IP Address into your browser. The default
IP Address is 192.168.2.1. If this has been changed, type in the new IP Address.
From the menu on the left, click Wizard.
1.
Wait 60 seconds after connecting power. The computer gets IP address 192.168.2.100 via DHCP.
2.
In a web browser, enter IP address 192.168.2.1.
3.
Login using admin as both the Username and Password. If you are using the default password, it will
prompt you to change it for future logins.
4.
Click Wizard on the left.
5.
Click Next.
6.
Change password, if desired and click Next. (Recommended)
7.
Set the device's Time Zone and click Next.
8.
Enter and configure APN.
a.
Select Manual Configuration.
b.
Set Country to Others.
c.
Enter the APN provided by the SIM provider.
d.
Click Next.
9.
Click Apply.
10.
Wait a few minutes and check LED status. Power, SIM, Internet, and Signal LEDs are on when there is a
live Internet connection. For more information on the LEDs, refer to LED Indicators.
After the device has a valid Internet connection, your computer automatically renews to the new IP address
assigned to cellular connection and has full access to the Internet.
10
®
MultiConnect
eCell User Guide
Advertisement
Table of Contents
